设置
快速交货
免运费
国际贸易术语
支付类型
市场产品
Slide 1
Slide 2
Slide 3
Slide 4
Slide 5
Slide 6
Slide 7
Slide 8
Slide 9
Slide 10
Slide 11
Slide 12
Slide 13
Slide 14
Slide 15
Slide 16
Slide 17
Slide 18
Slide 19
Slide 20
Slide 21
Slide 22
Slide 23
Slide 24
Slide 25
Slide 26
Slide 27
Slide 28
Slide 29
Product List
Because of the PWM drive, the neutral point is not a standstill point. The potential of this point is jumping up and down. It generates high common mode voltage and high frequency noise. For example, if the DC bus is 300 V, the neutral voltage can be as high as half the DC voltage, which is way beyond typical common mode voltage range for logic chips. A Voltage divider and low pass filter therefore is needed to reduce the common mode voltage and smooth the high frequency noise. The voltage divider will reduce the signal sensitivity at low speed, especially at start-up where it is needed most, and the low pass filter will induce too much delay for high speed. Consequently, this method tends to have a narrow speed range.
PTM Published on: 2015-04-06
