WRL-13231: SparkFun ESP8266 Thing

Summary

The SparkFun ESP8266 Thing is a breakout and development board for the ESP8266 WiFi SoC – a leading platform for Internet of Things (IoT) or WiFi-related projects. The Thing is low-cost and easy to use, and Arduino IDE integration can be achieved in just a few steps. We've made the ESP8266 easy to use by breaking out all of the module’s pins, adding a LiPo charger, power supply, and all of the other supporting circuitry it requires.

Why the name? We lovingly call it the “Thing” due to it being the perfect foundation for your Internet of Things project. The Thing does everything from turning on an LED to posting data with datastream, and can be programmed just like any microcontroller. You can even program the Thing through the Arduino IDE by installing the ESP8266 Arduino addon.

The SparkFun ESP8266 Thing is a relatively simple board. The pins are broken out to two parallel, breadboard-compatible rows. USB and LiPo connectors at the top of the board provide power – controlled by the nearby ON/OFF switch. LEDs towards the inside of the board indicate power, charge, and status of the IC. The ESP8266’s maximum voltage is 3.6V, so the Thing has an onboard 3.3V regulator to deliver a safe, consistent voltage to the IC. That means the ESP8266’s I/O pins also run at 3.3V, you’ll need to level shift any 5V signals running into the IC. A 3.3V FTDI Basic is required to program the SparkFun ESP8266 Thing, but other serial converters with 3.3V I/O levels should work just fine as well. The converter does need a DTR line in addition to the RX and TX pins.

Specifications

Manufacturer	SparkFun Electronics
Category	Open Source MCU Platforms
Eval Board Part Number	1568-1117-ND
Eval Board Supplier	SparkFun Electronics
IDE	Arduino IDE, with Software Add-on
Speed	80 MHz
Bits	32 Bit
Memory, Flash/RAM	4 MB / 520 kB
Digital I/O	12 I/O, 11 PWM
Interface	I²C x1 SPI x1 UART x1
Analog Outputs (DACs)	0
Analog Inputs (ADCs)	1 x 10 Bit (1.0V Limit)
DMA Channels	0
Features	Battery Charger, LiPo On-Board Antenna Power/Enable Pin
Radio	Wi-Fi 802.11 b/g/n
Interrupt Pins	0
I/O Voltage	3.3 V
Voltage In	3 ~ 6 V
Touch Sensing Pins	0
Program/Debug Interface	USB to Serial
Area	1432² mm, 2.22² In
Main I.C. Base Part	ESP8266EX
Design Author	SparkFun Electronics
Date Created By Author	2015-05
Date Added To Library	2019-09