The TPA3156D2 has low idle power loss and helps to extend the battery life of Bluetooth/Wireless speakers and other battery-powered audio systems. The high efficiency of the TPA3156D2 device allows it to do 2 × 70 W with external heat sink on a dual layer PCB. This device integrates an efficiency boost mode, which dynamically reduces the current ripple of the external LC filter and the idle current.
The TPA3156D2 advanced oscillator/PLL circuit employs a multiple switching frequency option to avoid AM interferences, which is achieved together with an option of either master or slave option, making it possible to synchronize multiple devices.
The TPA3156D2 devices are fully protected against faults with short-circuit protection and thermal protection as well as overvoltage, undervoltage, andDC protection. Faults are reported back to the processor to prevent devices from being damaged during overload conditions.
Features:
2 × 70 W Into a 4-Ω BTL Load at 24 V
Wide Voltage Range: 4.5 V to 26 V
Efficient Class-D Operation
~ Very Low Idle Current: <23 mA for recommended LC filter configurations
~ Greater than 90% Power Efficiency
~ Adaptive Modulation Schemes based on Output Power
Multiple Switching Frequencies
~ AM Avoidance
~ Master and Slave Synchronization
~ 300-KHz to 1.2-MHz Switching Frequency
Feedback Power-Stage Architecture With High PSRR Reduces PSU Requirements
Programmable Power Limit
Parallel BTL Mode and Mono-Channel Mode Support
Supports Both Single and Dual Power Supply Modes
Integrated Self-Protection Circuits Including Overvoltage, Undervoltage, Overtemperature, DC-Detect, and Short Circuit With Error Reporting
Thermally Enhanced Packages
~ DAD (32-Pin HTSSOP Pad Up)
Pin to Pin Compatible with TPA3116D2 and TPA3126D2
Manufacturer | Texas Instruments |
---|---|
Category | Audio Amplifiers |
Eval Board Part Number | 296-TPA3156D2EVM-ND |
Eval Board Supplier | Texas Instruments |
Eval Board |
Normally In Stock
|
Amplifier Type |
Class D
|
Number of Outputs |
Stereo
|
Output Power (RMS) @ Load |
70 W x 2 @ 4 Ω
|
Voltage In |
4.5 ~ 26 V
|
THD+N (1kHz) @ Conditions |
< 0.1% @ 15 W (4 Ω, 21 V)
|
Features |
Over Voltage Protection
Short Circuit Protection Thermal Protection Under Voltage Protection, Brown-Out |
Efficiency @ Conditions |
>87%, 12 V in, 8 Ω @ 3 ~ 22 W
>82%, 12 V in, 4 Ω @ 2.5 ~ 37.5 W >80%, 12 V in, 2 Ω @ 2.5 ~ 36 W |
Standby Current [Typical] |
30 µA
|
Quiescent Current [Typical] |
23 mA
|
Component Count + Extras |
45 + 63
|
Application / Target Market |
Audio: Home Theater Systems
Audio: Soundbar Audio: Wireless Speakers |
Design Author |
Texas Instruments
|
Main I.C. Base Part |
TPA3156
|
Quiescent Current [Maximum] |
- Not Given
|
Standby Current [Maximum] |
- Not Given
|
Date Created By Author | 2017-10 |
Date Added To Library | 2025-06 |