Vicor's assembly guideline for their ZVS buck and buck-boost 10 x 10 mm and 10 x 14 mm LGA/BGA packages.
The information contained in this document defines the handling procedures and assembly processing conditions for successful attachment to a printed circuit board.
The information contained in this document defines the handling procedures and assembly processing conditions required for successful attachment to a PCB.
This document details I 2C communication for all versions of VIT270H3U600yzzz.
The module utilizes Vicor proprietary technology to enable high efficiency and power density for this highly rugged, conduction-cooled model.
This document is intended to provide guidance to users of the Vicor Converter housed in Package (ChiP) Technology to physically integrate ChiPs having through-hole leads into higher-level assemblies.
Not long ago, designing a 1,000W power supply for operation on worldwide AC lines was a task for the most experienced power design engineers.
Vicor’s VI-200/VI-J00 and Maxi, Mini and Micro family DC-DC converters are voltage regulating devices, but their wide trim range makes it possible to use them as efficient high-power current sources.
Some applications employ power modules with greater output current capability than required by the load.
This application note applies to all Vicor through-hole ChiP™ devices.
An off-line battery charger — using the Unitrode UC3906 battery charger controller chip and a Vicor Maxi, Mini, Micro Series DC-DC converter module — provides design flexibility, small size, and high efficiency.
The design of a filter network is generally needed for DC-DC converters to have low electromagnetic interference (EMI) and high input noise rejection.
This application note provides soldering process information for PCB mount VIA products including the MFM™, AIM™, PFM™, VIA BCM® VIA DCM™, etc.
Electrical systems in military vehicles are normally required to meet stringent transient requirements.
For applications that require high voltage outputs, multiple converters may be used in a series output configuration to produce a single output voltage that is the sum of all of the converter outputs in the array.
RoHS compliant, through-hole full size VI Chips are intended for wave soldering assembly. The information contained in this document defines the processing conditions required for mounting a full size VI Chip to the PCB using wave soldering or hand soldering.
The output of Vicor 2nd Generation DC-DC converter modules can be programmed from 10 to 110% of their nominal output voltage.
The following discussion shows how to comply with these standards using modular Vicor DC-DC converters to facilitate the design of complex power supplies.
The DC-DC Converter Module (DCM) provides isolation, regulation, fault protection and monitoring in a single module.
In this application note we will consider 24V systems only, primarily because they are more prevalent where high-end equipment is likely to be used, but also because the same circuits – with small modifications – can be used to meet the requirements of the 12V systems.